DC Races
Description DC races are offered for use with the DC freewheel cages shown on the previous pages.
The cage and race assembly, makes a non bearing supported freewheel. Bearing support for axial and radial loads must be provided,along with lubrication and sealing.
The sprag space tolerance must not be exceeded when all bearing clearances and mounting tolerances are considered, (see table page 45).
Taper between races should be below 0,007 mm for 25 mm width.
Outer races type A and B should be pressed into housings that will not deform after assembly.
Please contact our technical department if you need to transmit maximum freewheel torque capacity with A and G type. - Key stresses may have to be checked.
Modelos:
DC Races
 |
|